Removal Procedure
WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
- Using the appropriate trim tool, remove the windshield wiper arm finish caps (1) from the windshield wiper arms (3).
- Windshield Wiper Arm Nut (2) - Remove [2x]
- Grasp the outer end of the windshield wiper arm (3) and gently rock the arm back and forth to remove it from the windshield wiper transmission pivot shaft.
- Windshield Wiper Arm (3) - Remove [2x]
Apply two layers of masking tape around the top edge of the air inlet grille panel extension (1) to prevent paint damage.
- Using a suitable plastic trim tool, carefully release the air inlet grille panel extension (1) clips.
- Remove the air inlet grille panel extension (1) from the air inlet grille panel and upper front fender.
- Air Inlet Grille Panel Extension (1) - Remove [2x]
Hood Rear Outer Air Inlet Seal Retainer (1) - Remove [4x]
- Hood Rear Outer Air Inlet Seal (2) - Remove [2x]
Air Inlet Grille Panel Retainer (1) - Remove [6x]
- Disconnect the windshield washer nozzle hose from the windshield washer pump hose.
- Lift the front edge of the air inlet grille panel (2) and slide the panel forward from both hood hinges to remove.
Air Inlet Deflector Water Deflector Retainer (1) - Remove [2x]
Air Inlet Deflector Water Deflector (1) - Remove