Removal Procedure

WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.

Set the parking brake in Service Mode. Parking Brake Service Mode Selection
Disconnect the battery negative cable. Battery Negative Cable Disconnection and Connection
Raise and support the vehicle. Lifting and Jacking the Vehicle
Remove the rear tire and wheel assembly. Tire and Wheel Removal and Installation
Have an assistant apply the brakes.
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
DO NOT use air tools to remove the wheel drive shaft nut. Damage to the wheel drive shaft threads could occur. Use hand tools only.

Rear Wheel Drive Shaft Nut (1) - Remove and DISCARD
Courtesy of GENERAL MOTORS COMPANY

Install the DT-45859 Axle Remover (1) to the rear wheel hub and secure with 3 wheel nuts (2) hand tightened.
Using the DT-45859 Axle Remover (1), release the rear wheel drive shaft from the rear wheel hub.
Remove the 3 wheel nuts (2) and the DT-45859 Axle Remover (1) from the rear wheel hub.
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Support the brake caliper with heavy mechanic wire, or equivalent, whenever it is separated from its mount and the hydraulic flexible brake hose is still connected. Failure to support the caliper in this manner will cause the flexible brake hose to bear the weight of the caliper, which may cause damage to the brake hose and in turn may cause a brake fluid leak.

NOTE:
Do NOT disconnect the hydraulic brake flexible hose from the caliper.

Rear Brake Caliper Bracket Bolt (1) - Remove
Remove the rear brake caliper and bracket (2) and support with heavy mechanics wire.
Courtesy of GENERAL MOTORS COMPANY

Rear Brake Rotor Bolt (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Rear Brake Rotor (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Rear Wheel Speed Sensor Bolt (1) @ Rear Suspension Knuckle - Remove
Rear Wheel Speed Sensor (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Rear Wheel Hub Bolt (1) - Remove [3x]
Courtesy of GENERAL MOTORS COMPANY

NOTE:
The rear brake shield (2) will become dislodged when the rear wheel hub (1) is removed.

Rear Wheel Hub (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Align the wheel bolt (1) with the relief (2) on the rear wheel hub.
Courtesy of GENERAL MOTORS COMPANY

Use the CH-43631 Ball Joint Separator (1) to release the wheel bolt (2) from the flange.
Courtesy of GENERAL MOTORS COMPANY

Wheel Bolt (1) - Remove and DISCARD