Installation Procedure
WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
Rear Suspension Lower Trailing Link (1) - Install
- CAUTION:
This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component.
Rear Suspension Trailing Arm Bracket Bolt (1) - Install NEW
- Rear Suspension Trailing Arm Bracket Nut (2) - Install, but do NOT tighten
Rear Suspension Trailing Arm Bolt (3) - Install NEW
- Rear Suspension Trailing Arm Nut (1) - Install
- Remove the jack stand from under the rear suspension knuckle
- Rear Suspension Trailing Arm Bolt (3) - Tighten - Fastener Specifications
Rear Suspension Trailing Arm Bracket Nut (1) - Tighten - Fastener Specifications
- Install the rear tire and wheel assembly. Tire and Wheel Removal and Installation
- Remove the support and lower the vehicle.
CAUTION:
Refer to Fastener Caution .