Installation Procedure

WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.

Prepare the 2 rear brake caliper bracket bolts as follows:
1. Remove any loose cured adhesive from the external threads of the components using a lint free cloth.
2. Thread the cleaned components into the internal mating threads and remove to loosen trapped cured adhesive.
3. Apply thread locking adhesive to the external threads of the components. Adhesives, Fluids, Lubricants, and Sealers
4. Ensure there are no gaps in the thread locking adhesive once applied to the component.
Courtesy of GENERAL MOTORS COMPANY

Rear Brake Caliper Bracket (2) - Install

CAUTION:

Fastener Caution

Rear Brake Caliper Bracket Bolt (1) - Install and tighten [2x] - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Rear Brake Caliper (1) - Install
Courtesy of GENERAL MOTORS COMPANY

NOTE:
DO NOT use any air tools to remove or install the guide pin bolts. Use hand tools ONLY.

Rear Brake Caliper Guide Pin Bolt (1) - Install and tighten [2x] - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

{If equipped} Rear Disc Brake Pad Wear Sensor (1) - Install
{If equipped} Rear Brake Caliper Bleeder Valve Cap (2) - Install
{If equipped} Retainer (3) - Install
Install the tire and wheel assembly. Tire and Wheel Removal and Installation
Connect the battery negative cable. Battery Negative Cable Disconnection and Connection
Exit parking brake service mode. Parking Brake Service Mode Selection