Installation Procedure
WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
Front Disc Brake Pad Wear Sensor (2) - Install
- Front Brake Caliper Bleeder Valve Cap (1) - Install
Retainer (1) - Secure [2x]
Retainer (3) - Secure [3x]
- Pull the front wheelhouse liner outwards to gain clearance to connect the electrical connector (1), and to secure the retainer (2).
- Retainer (2) - Secure
- Electrical Connector (1) - Connect
Engine Front Splash Shield (2) - Install
- Engine Front Splash Shield Bolt (1) - Install and tighten [5x] - Fastener Specifications
- Engine Front Splash Shield Retainer (3) - Install [2x]
- Install the front tire and wheel assembly. Tire and Wheel Removal and Installation
- Remove the support and lower the vehicle.
- Using a scan tool, relearn the front disc brake pad wear sensor.
CAUTION: