Removal Procedure
WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
- Raise and support the vehicle. Lifting and Jacking the Vehicle
- Remove the front tire and wheel assembly. Tire and Wheel Removal and Installation
Engine Front Splash Shield Retainer (3) - Remove [2x]
- Engine Front Splash Shield Bolt (1) - Remove [5x]
- Engine Front Splash Shield (2) - Remove
Pull the front wheelhouse liner outwards to gain clearance to disconnect the electrical connector (1), and to release the retainer (2).
- Electrical Connector (1) - Disconnect
- Retainer (2) - Release
- Retainer (3) - Release [3x]
Retainer (1) - Release [2x]
Front Brake Caliper Bleeder Valve Cap (1) - Remove
- Front Disc Brake Pad Wear Sensor (2) - Remove
NOTE:
If sensor is worn from contact with the front brake rotor, then the front disc brake pads must be replaced as well. Front Disc Brake Pads Replacement (JE5) , or Front Disc Brake Pads Replacement (J55) , or Front Disc Brake Pads Replacement (J6G)