Installation Procedure
WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
Install the transfer case control module (2) then engage the 2 retaining tabs (1).
- Connect the transfer case control module electrical connectors.
Rear Compartment Side Trim-Left Side (2) - Install
- Rear Compartment Side Trim Insulator Retainer (1) - Install [4x]
Rear End Trim Finish Panel (1) - Install
Rear End Trim Finish Panel Opening Cover (1) - Install
Rear Compartment Floor Panel Trim (1) - Install
Cargo Tie Down Loop (3) - Install [2x]
- Cargo Tie Down Loop Bolt (2) - Install and tighten [2x] - Fastener Specifications
- Cargo Tie Down Loop Bolt Cap (1) - Install [2x]
- After replacing the transfer case control module, record the clutch calibration identification number. Transfer Case Identification
- Program K69 transmission control module. K69 Transfer Case Control Module: Programming and Setup
CAUTION:
Refer to Fastener Caution .