Component Testing
WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.
Static Test
- Ignition/Vehicle - Off
- Disconnect the electrical connector: Q43 Valve Lifter Oil Manifold
- Test for 10 to 20 ohms between the test points:
- Control circuit terminal 1 & Ignition circuit terminal
- Control circuit terminal 2 & Ignition circuit terminal
- Control circuit terminal 3 & Ignition circuit terminal
- Control circuit terminal 5 & Ignition circuit terminal
- If not between 10 and 20 ohms
Replace the component: Q44 Engine Oil Pressure Control Solenoid Valve
- Go to next step: If between 10 and 20 ohms
- Test for infinite resistance between the test points: Each terminal of the component & The component's housing
- If less than infinite resistance
Replace the component: Q43 Valve Lifter Oil Manifold
- Go to next step: If infinite resistance
- If less than infinite resistance
- All OK.