Single Use Fasteners and Components
WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.
- Cylinder Head Bolt [10x]
- Cylinder Head Gasket
| Callout | Component Name |
|---|---|
| Preliminary Procedure Clean the holes in the block of any debris or residual fastener thread sealant. Failing to do so can cause the bolts not to reach proper torque and/or clamp load. |
|
| 1 | Cylinder Head Gasket
NOTE:
Must use NEW gasket. |
| 2 | Cylinder Head Assembly |
| 3 | Cylinder Head Bolt
CAUTION:
This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component.
CAUTION:
Refer to Fastener Caution . Procedure Tighten the cylinder head bolts each pass in the sequence shown. Tighten 80 N.m (59 lb ft) + 90° + 60° |