Removal Procedure
WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.
Remove the clutch actuator cylinder pipe retaining clip (1) from the clutch master cylinder pipe.
- Remove and DISCARD the zip ties (2) that hold the clutch master cylinder pipe (3) in place.
- Install a cap or plug to the exposed hose and clutch master cylinder fittings in order to prevent fluid loss and contamination.
- Disconnect the clutch actuator cylinder pipe (3) from the clutch master cylinder pipe.
- Raise and support the vehicle. Lifting and Jacking the Vehicle
Warm Up Three-Way Catalytic Converter - Right Side(1) - Remove - Warm Up Three-Way Catalytic Converter Replacement - Right Side (LGY)Warm Up Three-Way Catalytic Converter Replacement - Right Side (LT4)
- Remove the clutch actuator cylinder pipe retaining clip (1) from the transmission.
- Disconnect the clutch actuator cylinder pipe (3) from the transmission. Plug the lower hose end.
- Remove the clutch actuator cylinder pipe (3).
CAUTION:
Care must be taken when disassembling the clutch actuator cylinder hose connector from the clutch actuator cylinder. Do not remove, misposition, or damage the internal restrictor valve/Peak Torque Limiter (PTL). Operating a vehicle with a removed, mispositioned, or damaged PTL valve could result in severe driveline damage.
- Remove the manual transmission from the vehicle. Manual Transmission Removal and Installation
Remove the clutch actuator cylinder bolts (1).
- Remove the clutch actuator cylinder (2) from the manual transmission.