Installation Procedure
WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.
- Position the clutch actuator cylinder pipe in the vehicle.
Remove the cap or plug from the exposed hose and clutch master cylinder fittings.
- Connect the clutch actuator cylinder pipe (3) to the clutch master cylinder pipe.
- Install the clutch actuator cylinder pipe retaining clip (1) to the clutch master cylinder pipe.
- Connect the clutch actuator cylinder pipe (3) to the transmission.
- Install the clutch actuator cylinder pipe retaining clip (1) to the transmission.
- Install NEW zip ties (2) that hold the clutch master cylinder pipe (3) in place.
Warm Up Three-Way Catalytic Converter - Right Side(1) - Install - Warm Up Three-Way Catalytic Converter Replacement - Right Side (LGY)Warm Up Three-Way Catalytic Converter Replacement - Right Side (LT4)
- Bleed the clutch hydraulic system. Hydraulic Clutch System Bleeding
- Lower the vehicle.
Install the clutch actuator cylinder (2) on the manual transmission.
- Install and tighten the clutch actuator cylinder bolts (1). Fastener Specifications
- Install the manual transmission to the vehicle. Manual Transmission Removal and Installation
CAUTION:
Refer to Fastener Caution .