Installation Procedure
WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.
- NOTE:
Typical rear rotor is shown, actual rotor will vary based on RPO.
Parking Brake Caliper (2) - Install
- Parking Brake Bolt (1) - Install and tighten [2x] 58 N.m (43 lb ft)
- Connect the parking brake actuator electrical connector.
- NOTE:
Typical rear rotor is shown, actual rotor will vary based on RPO.
Parking Brake Caliper Outer Pad (2) - Install
- Parking Brake Caliper Inner Pad (1) - Install
- NOTE:
Typical rear rotor is shown, actual rotor will vary based on RPO.
Parking Brake Caliper Pad Spring (1) - Install
- Parking Brake Caliper Pin (2) - Install [2x]
- NOTE:
Typical rear rotor is shown, actual rotor will vary based on RPO.
Parking Brake Caliper Pin Clip (1) - Install [2x]
- Install the rear tire and wheel assembly. Tire and Wheel Removal and Installation (without J57) , or Tire and Wheel Removal and Installation (with J57)
- Remove the support and lower the vehicle.
- Calibrate the electronic parking brake. Park Brake Calibration
CAUTION: