Installation Procedure
WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.
Assemble the EN-52287 Balancer Holder Kit (1) as shown.
- NOTE:
Align the notch of the crankshaft balancer to the timing pin in the crankshaft.
Crankshaft Balancer (2) - Install
- Crankshaft Balancer Bolt (1) - Install NEW and hand tighten
Install the EN-52287 Balancer Holder Kit (1) into the crankshaft balancer (2).
- Position the EN-956-1 Extension Handle (3) against the top of the drivetrain and front suspension cradle as shown.
- Crankshaft Balancer Bolt (4) - Tighten
- First Pass: 150 N.m (111 lb ft)
- Final Pass: 140 Degrees
- Front Compartment Air Deflector - Install - Front Compartment Air Deflector Replacement (AWD) , or Front Compartment Air Deflector Replacement (RWD)
Accessory Drive Primary Belt (1) - Install - Accessory Drive Primary Belt Replacement
CAUTION:
Refer to Fastener Caution .
CAUTION:
Refer to Torque-to-Yield Fastener Caution .