Installation Procedure

WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Transmission Fluid Cooler Pipe Seal (1) - Install NEW [2x]
Courtesy of GENERAL MOTORS COMPANY

Transmission Fluid Cooler Seal (2) - Install NEW
Transmission Fluid Cooler Pipe Seal (1) - Install NEW [2x]
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Remove the caps from the fittings and plugs from the holes before installing the transmission fluid cooler pipes.

Transmission Fluid Cooler Inlet and Outlet Pipe (2) - Install

CAUTION:

Refer to Fastener Caution .

Transmission Fluid Cooler Pipe Nut (1) - Install and tighten to 22 N.m (16 lb ft)
Courtesy of GENERAL MOTORS COMPANY

Transmission Fluid Auxiliary Cooler Pipe Bracket Nut (1) - Install and tighten to 22 N.m (16 lb ft)
Courtesy of GENERAL MOTORS COMPANY

Transmission Fluid Cooler Pipe Clip Bolt (3) - Install and tighten [2x] 9 N.m (80 lb in)
Transmission Fluid Cooler Pipe Bolt (2) - Install and tighten to 22 N.m (16 lb ft)
Transmission Fluid Cooler Pipe Nut (1) - Install and tighten [2x] 22 N.m (16 lb ft)
Lower the vehicle.
Check the transmission fluid level. Transmission Fluid Level and Condition Check
Inspect for transmission fluid leaks. Fluid Leak Diagnosis