Installation Procedure
Feed the battery positive cables (2) into the engine compartment and engage the harness grommet (1).
Battery Positive Cable (5) - Install [2x]
- Auxiliary Generator Battery Jumper Cable (4) - Install
- Auxiliary Generator Battery Jumper Cable Nut (3) - Install - Engine Wiring Harness Fuse Block Bracket Replacement
- Battery Positive Cable Nut (1) - Install - Battery Distribution Fuse Block Replacement
- Fuse Block Cover (2) - Install
Retainer (2) - Engage [2x]
- Engage the battery positive cables (1) into the harness retainer channel.
- Brake Master Cylinder - Install - Brake Master Cylinder Replacement - With Power Brake Booster and Electronic Brake Control Module (without MJK) , or Brake Master Cylinder Replacement - With Power Brake Booster and Electronic Brake Control Module (with MJK)
Retainer (1) - Engage [5x]
Driver Footrest Bracket (3) - Install
- Footrest Bracket Nut (2) - Install and Tighten [2x] - 3 N.m (27 lb in)
- Retainer (1) - Engage
Install the battery positive cable (2) into the harness channel.
- Retainer (1) - Engage
Engage the battery positive cable (2) to the harness channel retainers (1).
- Feed the battery positive cable into the rear compartment.
Retainer (2) @Rear Body Fuse Block Bracket (1) - Engage
Battery Positive Cable (3) - Install [2x]
- Battery Positive Cable Nut (1) - Install [2x] - Battery Distribution Fuse Block Replacement
- Retainer (2) - Engage [2x]
Rear Body Fuse Block Cover (2) - Install - Rear Body Fuse Block Cover Replacement
Install the left side front floor panel carpet (3). Front Floor Panel Carpet Replacement - Left Side
Install the left side rear floor panel carpet (2). Rear Floor Panel Carpet Replacement
Install the left side rear seat back bolster (2). Rear Seat Back Bolster Replacement
- Connect the battery negative cable. Battery Negative Cable Disconnection and Connection