Rear Compartment Lid Adjustment

WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

NOTE: Callouts in the following chart represent components shown in graphic above.

Callout	Component Name
1	Rear Compartment Lid Procedure Loosen the 4 rear compartment lid bolts to adjust the rear compartment lid. Adjust the rear compartment lid in order to obtain an even gap between the lid and the quarter outer panel, the tail lamp and rear bumper fascia and so that the lid is flush with the quarter outer panel, the tail lamp and rear bumper fascia. Tighten the 4 rear compartment lid bolts. Rear Compartment Lid Replacement Adjustment: Rear compartment lid to quarter outer panel (a) 3.5 mm ± 0.75 mm (0.14 in ± 0.03 in) Rear compartment lid to rear body structure stop lamp (b) 3.5 mm ± 1.0 mm (0.14 in ± 0.04 in) Rear compartment lid to rear bumper fascia (c) 6.0 mm ± 1.5 mm (0.24 in ± 0.05 in)

Callout

Component Name

Rear Compartment Lid

Procedure

Loosen the 4 rear compartment lid bolts to adjust the rear compartment lid.
Adjust the rear compartment lid in order to obtain an even gap between the lid and the quarter outer panel, the tail lamp and rear bumper fascia and so that the lid is flush with the quarter outer panel, the tail lamp and rear bumper fascia.
Tighten the 4 rear compartment lid bolts. Rear Compartment Lid Replacement

Adjustment:

Rear compartment lid to quarter outer panel (a) 3.5 mm ± 0.75 mm (0.14 in ± 0.03 in)
Rear compartment lid to rear body structure stop lamp (b) 3.5 mm ± 1.0 mm (0.14 in ± 0.04 in)
Rear compartment lid to rear bumper fascia (c) 6.0 mm ± 1.5 mm (0.24 in ± 0.05 in)