LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2021 >> CT4 Sport, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 301 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Fuel Tank Filler Pipe Housing Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the right rear wheel. Tire and Wheel Removal and Installation (without J57) , or Tire and Wheel Removal and Installation (with J57)
  2. GM5317301Courtesy of GENERAL MOTORS COMPANY

    Rear Tire Front Air Deflector(2) - Remove

  3. GM5448092Courtesy of GENERAL MOTORS COMPANY

    Rear Wheelhouse Liner(2) - Remove - Rear Wheelhouse Liner Replacement

  4. GM5310033Courtesy of GENERAL MOTORS COMPANY

    Fuel Tank Filler Door(1) - Remove - Fuel Tank Filler Door Replacement 

  5. GM5314503Courtesy of GENERAL MOTORS COMPANY

    Fuel Tank Filler Pipe Ground Bolt(1) - Remove

  6. GM5522555Courtesy of GENERAL MOTORS COMPANY

    Fuel Tank Filler Pipe Ground Bolt(1) - Remove

  7. Lift the fuel tank filler pipe up and out to disengage tab from vehicle.
  8. NOTE:

    When replacing the fuel tank filler pipe housing or door, always install NEW fuel labels to the component that was replaced.

  9. Reposition the fuel tank filler pipe rearward and rotate outward from under the body side outer panel to remove from fuel tank filler pipe housing.
  10. GM5448091Courtesy of GENERAL MOTORS COMPANY

    Rotate fuel tank filler pipe housing (1) to remove from body side outer panel

  11. Disconnect the electrical connector.