Installation Procedure

WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Front Fender- Left Side - Install
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Refer to Fastener Caution .

Front Fender Bolt(1) - Install and tighten [6x] 9 N.m (80 lb in)
Front Fender Nut(2) - Install and tighten9 N.m (80 lb in)
Remove the double layer of masking tape from the windshield.
Courtesy of GENERAL MOTORS COMPANY

Front Fender Bolt(1) - Install and tighten [2x] 9 N.m (80 lb in)
Headlamp Bolt(2) - Install and tighten2.5 N.m (22 lb in)
Courtesy of GENERAL MOTORS COMPANY

Rocker Panel Molding(2) - Install - Rocker Panel Molding Replacement , or Rocker Panel Molding Replacement (Blackwing)
Courtesy of GENERAL MOTORS COMPANY

Front Bumper Fascia Guide(3) - Install - Front Bumper Fascia Guide Replacement
Courtesy of GENERAL MOTORS COMPANY

Front Fender InsulatorLeft Side(2) - Install - Front Fender Insulator Replacement - Left Side
Courtesy of GENERAL MOTORS COMPANY

Front Compartment Side Sight Shield- Front(2)Install - Front Compartment Side Sight Shield Replacement - Front (Blackwing)
Courtesy of GENERAL MOTORS COMPANY

Front Compartment Side Sight Shield(2)Install - Front Compartment Side Sight Shield Replacement (without Blackwing) , or Front Compartment Side Sight Shield Replacement (with Blackwing)
Courtesy of GENERAL MOTORS COMPANY

Air Inlet Grille Panel Extension - Left Side(1) - Install - Air Inlet Grille Panel Extension Replacement - Left Side
Courtesy of GENERAL MOTORS COMPANY

Front Bumper Fascia(1) - Install - Front Bumper Fascia Replacement (without Blackwing) , or Front Bumper Fascia Replacement (with Blackwing)