Installation Procedure
Front Compartment Front Panel (1) - Install
- CAUTION:
Refer to Fastener Caution .
Install and tighten the 3 left side upper front compartment front bolts (1). 22 N.m (16 lb ft)
Install and tighten the 5 left side lower front compartment front bolts (1).22 N.m (16 lb ft)
Install and tighten the right 3 side upper front compartment front bolts (1). 22 N.m (16 lb ft)
Install and tighten the 5 right side lower front compartment front bolts (1). 22 N.m (16 lb ft)
- Position the wiring harness.
Body Wiring Harness Junction Block Bracket - Install - Body Wiring Harness Junction Block Bracket Replacement
Transmission Control Module Bracket(2) - Install - Transmission Control Module Bracket Replacement
Engine Control Module Bracket(1) - Install - Engine Control Module Bracket Replacement
Hood Primary Latch Release Cable (1) - Install - Hood Primary Latch Release Cable Replacement
Intake Air Duct(1) - Install - Intake Air Duct Replacement
Radiator Air Side Upper Baffle- Left Side(1) - Install - Radiator Air Side Upper Baffle Replacement - Left Side (LT4)
Radiator Air Side Upper Baffle- Right Side(1) - Install - Radiator Air Side Upper Baffle Replacement - Right Side (LT4)
Radiator Air Front Upper Baffle(1) - Install - ***Radiator Air Front Upper Baffle Replacement (LSY) , or Radiator Air Front Upper Baffle Replacement (LGY)
Radiator Air Upper Baffle(1) - Install - Radiator Air Upper Baffle Replacement (LT4)
Radiator Upper Bracket - Left Side(2) - Install - Radiator Upper Bracket Replacement - Left Side (LT4)
Radiator Upper Bracket - Right Side(3) - Install - Radiator Upper Bracket Replacement - Right Side (LT4)
- NOTE:
Left side shown, right side similar.
Front Fender Front Brace- Left Side and Right Side(3) - Install [2x] - Front Fender Front Brace Replacement
- Intake Air Duct - Install - Intake Air Duct Replacement
Front Headlamp- Left Side and Right Side(2).Install [2x] - Front Headlamp Replacement (With T87) , or Front Headlamp Replacement (Without T87) , or Front Headlamp Replacement (Blackwing)
Install the 2 left and right side front end sheet metal cross brace at the impact bar (2). Front End Sheet Metal Cross Brace Replacement (Impact Bar Bracket) , or Front End Sheet Metal Cross Brace Replacement (Plenum without Blackwing) , or Front End Sheet Metal Cross Brace Replacement (Plenum with Blackwing)
Front Bumper Impact Bar(3) - Install - Front Bumper Impact Bar Replacement (with Blackwing)
Charge Air Cooler- Left Side(1) - Install - Charge Air Cooler Replacement - Left Side (LT4)
Charge Air Cooler- Right Side(1) - Install - Charge Air Cooler Replacement - Right Side (LT4)
Front Bumper Fascia Center Support(3) - Install - Front Bumper Fascia Center Support Replacement
Front Bumper Fascia Support Brace (2) - Install - Front Bumper Fascia Support Brace Replacement (Without Radar) , or Front Bumper Fascia Support Brace Replacement (With Radar)
- NOTE:
Left side shown, right side similar.
Front Wheelhouse Liner- Left Side and Right Side(1)Install - Front Wheelhouse Liner Replacement , or Front Wheelhouse Liner Replacement (Blackwing)
- NOTE:
Left side shown, right side similar.
Front Compartment Side Sight Shield- Left Side and Right Side(2) - Install
[2x]
Front Bumper Fascia (1) - Install - Front Bumper Fascia Replacement (without Blackwing) , or Front Bumper Fascia Replacement (with Blackwing)
Hood(2) - Install - Hood Replacement