LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2021 >> CT4 Sport, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 298 (Wiper System And Washer System) >> Diagnostic Information and Procedures >> Windshield Wiper System Malfunction >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify there are no wiper or communication related DTCs set in the K9 Body Control Module or the K219 Lighting Control Module.
    • Go to next step: If there are no DTCs set 
  2. Verify the Windshield Wiper Switch scan tool parameter changes to Off, Delay 1 - 5, Low, and High when operating the S82 Windshield Wiper/Washer Switch through all switch positions.
    • If the parameter changes, but not to all states 

      Replace the S82 Windshield Wiper/Washer Switch

    • If the parameter does not change 

      Refer to Circuit/System Testing - Windshield Wiper Switch Malfunction

    • Go to next step: If the parameter changes to all states 
  3. Verify the M75 Windshield Wiper Motor operates when cycling the S82 Windshield Wiper/Washer Switch through all switch positions.
    • If the M75 Windshield Wiper Motor does not operate 

      Refer to Circuit/System Testing - Windshield Wiper Motor Malfunction

    • Go to next step: If the M75 Windshield Wiper Motor operates 
  4. A fault is not currently present and may be an intermittent condition.