Installation Procedure
Electric Belt Drive Rack and Pinion Steering Gear (1) - Install
- Steering Gear Bolt (3) - Install NEW [2x]
- Steering Gear Nut (2) - Install and hand tighten [2x]
- Steering Gear Bolt (3) - Tighten [2x] - Electric Belt Drive Rack and Pinion Steering Gear Replacement (AWD)
Front Stabilizer Shaft (2) - Install
- Front Stabilizer Shaft Insulator Clamp Nut (1) - Install and tighten [4x] - Stabilizer Shaft Replacement (AWD)
- NOTE:
Left side shown, right side similar.
Front Lower Control Rear Link - Left Side and Right Side (3) - Install [2x]
- Front Lower Control Arm Rear Bolt - Left Side and Right Side (1) - Install NEW [2x]
- Front Lower Control Arm Rear Nut - Left Side and Right Side (2) - Install and hand tighten [2x]
- Front Lower Control Arm Rear Bolt - Left Side and Right Side (1) - Tighten [2x] - Front Lower Control Rear Link Replacement (AWD)
- NOTE:
Left side shown, right side similar.
Front Lower Control Front Link - Left Side and Right Side (3) - Install [2x]
- Front Lower Control Arm Front Bolt - Left Side and Right Side (1) - Install NEW [2x]
- Front Lower Control Arm Front Nut - Left Side and Right Side (2) - Install and hand tighten [2x]
- Front Lower Control Arm Front Bolt - Left Side and Right Side (1) - Tighten [2x] - Front Lower Control Front Link Replacement (AWD)
Drivetrain and Front Suspension Cradle (1) - Install - Drivetrain and Front Suspension Cradle Removal and Installation (AWD LGY)
This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component.
Refer to Fastener Caution
This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component.
This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component.