Installation Procedure
Raise the drivetrain and front suspension assembly (1) into position.
- CAUTION:
Refer to Fastener Caution
CAUTION:This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component.
Drivetrain and Front Suspension Cradle Front Bolt (1) - Install NEW and tighten [6x]
- First Pass: 100 N.m (74 lb ft)
- Final Pass: (90 - 105 degrees)
- Drivetrain and Front Suspension Cradle Rear Bolt (2) - Install NEW and tighten [2x]
- First Pass: 100 N.m (74 lb ft)
- Final Pass: (90 - 105 degrees)
- Remove the jack from the drivetrain and front suspension cradle.
Auxiliary Radiator Front Inlet Duct - Right Side (1) - Install - Auxiliary Radiator Front Inlet Duct Replacement - Right Side (LT4)
Auxiliary Radiator Front Inlet Duct - Left Side (1) - Install - Auxiliary Radiator Front Inlet Duct Replacement - Left Side (LT4)
- NOTE:
Left side shown, right side similar.
Front Lower Control Rear Link - Left Side and Right Side (2) @ Steering Knuckle - Remove [2x] - Front Lower Control Rear Link Replacement (RWD)
- Front Lower Control Front Link - Left Side and Right Side (1) @ Steering Knuckle - Remove [2x] - Front Lower Control Front Link Replacement (RWD)
Stabilizer Shaft Link (1) @ Stabilizer Shaft - Install - Stabilizer Shaft Link Replacement (FE2) , or Stabilizer Shaft Link Replacement (FE3, FE4)
Install the steering linkage outer tie rod (1) to the steering knuckle. Steering Linkage Outer Tie Rod Replacement (with Blackwing)
Intermediate Steering Shaft (1) @ Steering Gear - Install - Intermediate Steering Shaft Replacement (RWD)
Front Cradle Shear Plate (1) - Install - Front Cradle Shear Plate Replacement (Blackwing)
- NOTE:
Left side shown, right side similar.
Front Wheelhouse Liner - Left Side and Right Side (1) - Install [2x] - Front Wheelhouse Liner Replacement (Blackwing)
Engine Mount Nut-Right Side (1) - Install - Engine Mount Replacement - Right Side
Engine Mount Nut-Left Side (1) - Install - Engine Mount Replacement - Left Side
EN-51007 Global Engine Support Fixture (1) - Remove - Engine Support Fixture
- Remove the wire or strap used to secure the engine coolant fan module radiator assembly to the left and right side radiator upper brackets.
- If the front drivetrain and suspension cradle is replaced, measure and adjust the wheel alignment. Wheel Alignment Measurement
This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component.