Front Bumper Shutter Frame Replacement

WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

NOTE: Callouts in the following chart represent components shown in graphic above.

Callout	Component Name
Preliminary Procedures Front Bumper Fascia Energy Absorber Replacement Reposition the wiring harness.
1	Front Bumper Shutter Bolt [8x] CAUTION: Refer to Fastener Caution . Tighten 2 N.m (18 lb in)
2	Front Bumper Shutter Bolt- Upper [4x] Tighten 2.5 N.m (22 lb in) Disconnect the drivers information camera electrical connector.
3	Front Bumper Shutter Frame Procedure Pull the front bumper shutter frame up and out from behind the front bumper fascia absorber. Transfer components as necessary.