Installation Procedure

WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

With the aid of an assistant, install the front bumper fascia (1).
Connect the electrical connectors.
Courtesy of GENERAL MOTORS COMPANY

Install the front bumper fascia (1) to the left and right side headlamps and left and right side front bumper fascia guides.
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Refer to Fastener Caution .

Front Bumper Fascia Bolt (1) - Install and tighten [6x] 2.5 N.m (22 lb in).
Courtesy of GENERAL MOTORS COMPANY

Front Bumper Fascia Bolt- Left Side and Right Side (2) - Install and tighten [2x] 2.5 N.m (22 lb in)
Front Wheelhouse Liner- Left Side and Right Side (1) Install [2x]
Courtesy of GENERAL MOTORS COMPANY

Front Bumper Fascia Center Air Deflector Bolt (1) - Install and tighten [6x] 2.5 N.m (22 lb in)
Courtesy of GENERAL MOTORS COMPANY

Front Wheelhouse Liner Bolt- Left Side and Right Side (1) - Install [20x] - Front Wheelhouse Liner Replacement (Blackwing)
Courtesy of GENERAL MOTORS COMPANY

Front Wheelhouse Liner Bolt- Left Side and Right Side (1) - Install [2x] - Front Wheelhouse Liner Replacement (Blackwing)
Courtesy of GENERAL MOTORS COMPANY

Front Bumper Fascia Air Deflector (2) - Install
Front Bumper Fascia Air Deflector Bolt (1) - Install and tighten [4x] 2.5 N.m (22 lb in)
Courtesy of GENERAL MOTORS COMPANY

Front Compartment Front Sight Shield (2) - Install - Front Compartment Front Sight Shield Replacement
{ If equipped } Connect the engine coolant heater wiring extension harness connector to the license plate bracket.