Installation Procedure
WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.
Retaining Ring (2) @ Front Wheel Drive Half Shaft (1) - Install NEW
Front Wheel Drive Half Shaft (1) - Install
Partially install the front wheel drive half shaft (1) into the front differential carrier.
- Remove the DT-51504 Seal Protector (2) from the front axle shaft seal.
- Completely install the front wheel drive half shaft (1) into the front differential carrier.
- Steering Linkage Outer Tie Rod @ Steering Knuckle - Install - Steering Linkage Outer Tie Rod Replacement (without Blackwing) , or Steering Linkage Outer Tie Rod Replacement (with Blackwing)
- Front Suspension Strut @ Steering Knuckle - Install - Strut Assembly Removal and Installation (FE2, FE3, witout F55) , or Strut Assembly Removal and Installation (FE3, FE4, with F55)
- Have an assistant apply the brakes.
- CAUTION:
This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component.
CAUTION:Refer to Fastener Caution .
Front Wheel Drive Shaft Nut (1) - Install NEW and tighten
- First Pass: 150 N.m (111 lb ft)
- Second Pass: loosen 45 degrees
- Final Pass: 270 N.m (199 lb ft)
- Engine Front Splash Shield - Install - Engine Front Splash Shield Replacement (AWD) , or Engine Front Splash Shield Replacement (RWD)
- Install the right front tire and wheel assembly. Tire and Wheel Removal and Installation (without J57) , or Tire and Wheel Removal and Installation (with J57)
- Remove the support and lower the vehicle.
NOTE:
Ensure that the front wheel drive half shaft (1) is securely engaged to the front wheel drive intermediate shaft.