Installation Procedure
WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.
Rear Suspension Bracket (2) - Install
- Rear Suspension Bracket Bolt (4) - Install and tighten 58 N.m (43 lb ft)
- Rear Suspension Bracket Bolt (1) - Install and tighten 58 N.m (43 lb ft)
- Rear Suspension Cradle Front Bolt (3) - Install NEW and tighten
- First Pass: 100 N.m (74 lb ft)
- Final Pass: 90 - 105 degrees
- Underbody Rear Air Deflector - Install
- Remove the support and lower the vehicle.
CAUTION:
Refer to Fastener Caution .
CAUTION:
This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component.