Installation Procedure
WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.
Rear Shock Absorber (1) - Install
- CAUTION:
Refer to Fastener Caution .
Rear Suspension Shock Absorber Upper Mounting Nut (1) - Install and tighten [3x] 43 N.m (32 lb ft)
- Electrical Connector (2) - Connect
- CAUTION:
This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component.
Rear Shock Absorber Bolt (2) @Rear Suspension Lower Control Arm (3) - Install NEW and tighten
- First Pass: 100 N.m (74 lb ft)
- Final Pass: 90 - 105 degrees
- Remove the jack from beneath the rear suspension lower control arm.
Rear Suspension Lower Control Arm Cover (2) - Install - Rear Suspension Lower Control Arm Cover Replacement
- Rear Wheelhouse Liner - Install - Rear Wheelhouse Liner Replacement
- Install the rear tire and wheel assembly. Tire and Wheel Removal and Installation (without J57) , or Tire and Wheel Removal and Installation (with J57)
- Remove the support and lower the vehicle.