Installation Procedure
With the aid of an assistant, position the headlining trim panel (2) into the vehicle through the front windshield.
- Connect the electrical connectors.
- Tape any unused connectors to the headlining with a high adhesive tape.
- Engage the 4 headlining trim panel retainers (1) at the rear underside of the headlining trim panel (2).
- Push on headlining trim panel (2) around sunroof opening to seat the retainers.
- Windshield - Install - Windshield Replacement
Active Noise Cancellation Microphone Grille (1) - Install - Active Noise Cancellation Microphone Grille Replacement
High Mount Stop Lamp Opening Cover (1) - Install - High Mount Stop Lamp Opening Cover Replacement
Windshield Multifunction Sensor Mount Bracket Cover (1) - Install - Windshield Multifunction Sensor Mount Bracket Cover Replacement
Roof Console (1) - Install - Roof Console Replacement
Rear Window Panel Trim (2) - Install - Rear Window Panel Trim Replacement
Quarter Upper Trim Panel (3) - Install [2x] - Quarter Upper Trim Panel Replacement
Center Pillar Upper Trim Panel (3) - Install [2x] - Center Pillar Upper Trim Panel Replacement
Roof Rail Rear Seat Position Reading and Courtesy Lamp (1) - Install [2x] - Roof Rail Rear Seat Position Reading and Courtesy Lamp Replacement
Roof Rail Rear Assist Handle (2) - Install [2x] - Roof Rail Rear Assist Handle Replacement
Roof Rail Assist Handle (2) - Install [2x] - Roof Rail Assist Handle Replacement
Windshield Garnish Molding (2) - Install [2x] - Windshield Garnish Molding Replacement
Sunshade Support (2) - Install [2x] - Sunshade Support Replacement
Sunshade (3) - Install [2x] - Sunshade Replacement
- Enable the SIR System. SIR Disabling and Enabling