Fastener Specifications
WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.
Single Use Threaded Fastener/Component Tightening Specifications
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Front Lower Control Arm Front Bolt | |
|
100 N.m (74 lb ft) |
|
90 - 105 degrees |
| Front Lower Control Arm Rear Bolt | |
|
100 N.m (74 lb ft) |
|
90 - 105 degrees |
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Front Lower Control Arm Ball Stud Nut | |
|
40 N.m (30 lb ft) |
|
120 - 135 degrees |
| Front Stabilizer Shaft Insulator Clamp Nut (RWD) | |
|
13 N.m (10 lb ft) |
|
30 - 45 degrees |
| Front Stabilizer Shaft Insulator Clamp Nut (AWD) | 43 N.m (32 lb ft) |
| Front Stabilizer Shaft Link Nut- Lower | 130 N.m (96 lb ft) |
| Front Stabilizer Shaft Link Nut- Upper | 120 N.m (89 lb ft) |
| Front Strut Rod Mount Nut (FE2) | 82 N.m (61 lb ft) |
| Front Strut Rod Mount Nut (FE3) | 50 N.m (37 lb ft) |
| Front Suspension Strut Upper Mounting Nut | 27 N.m (20 lb ft) |
| Front Wheel Hub Bolt | |
|
100 N.m (74 lb ft) |
|
15 - 30 degrees |
| Steering Knuckle Nut | |
|
150 N.m (111 lb ft) |
|
80 - 95 degrees |