LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2021 >> CT4 Sport, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 269 (Exhaust System) >> Diagnostic Information and Procedures >> DTC P26C5-P26C7, P31CF-P31D7, or P31D9-P31DB (LGY without G96) >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition - On / Vehicle - In Service Mode
  2. Verify DTC P31D2, P31D6 is not set.
    • If any of the DTCs are set 

      Replace the component: M106S Exhaust Control Valve Actuator - Sound Quality-Right Side

    • Go to next step: If none of the DTCs are set 
  3. Verify DTC P31D3, P31D4, P31D5 is not set.
    • If any of the DTCs are set 
    1. Perform the following learn procedure: Exhaust Flow Control Valve Learn  @ K20 Engine Control Module
    2. Ignition/Vehicle & All vehicle systems - Off - For 2 min
    3. Ignition - On / Vehicle - In Service Mode
    4. Operate the vehicle within the Conditions for Running the DTC.

      Verify the DTC does not set.

      • If the DTC sets - Refer to: Circuit/System Testing - Test 2
      • Go to next step: If the DTC does not set
    5. All OK.
    • Go to next step: If none of the DTCs are set 
  4. Verify DTC P31D9, P31DA, P31DB is not set.
    • If any of the DTCs are set 

      Refer to: Circuit/System Testing - Test 2

    • Go to next step: If none of the DTCs are set 
  5. Perform the scan tool control function: Exhaust Control Valve Position @ K20 Engine Control Module - Open/Close

    Verify a click can be heard or felt at the following component(s) when the scan tool control function was commanded: M106S Exhaust Control Valve Actuator - Sound Quality-Right Side

    • If a click cannot be heard or felt 

      Refer to: Circuit/System Testing - Test 1

    • Go to next step: If a click can be heard or felt 
  6. Perform the scan tool control function: Exhaust Control Valve Position @ K20 Engine Control Module - Close

    Verify a condition does not exist with the component: M106S Exhaust Control Valve Actuator - Sound Quality-Right Side - Turns Off

    • Perform the action while monitoring the component:
    • Wiggle the harness and connector: M106S Exhaust Control Valve Actuator - Sound Quality-Right Side
    • Wiggle the harness and connector: K111 Fuel Pump Power Control Module
    • If a condition exists 

      Repair as necessary - Wiring / Terminal(s) / Electrical Connector(s)

    • Go to next step: If no condition exists 
  7. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.

    Verify the DTC does not set.

    • If the DTC sets 

      Repeat the procedure starting at step 2

    • Go to next step: If the DTC is not set 
  8. All OK.
scientia non olet · About LEMON Manuals