Installation Procedure

WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.

Due to the unknown shelf life of the adhesive patch, prepare the NEW brake caliper bracket bolts and bracket threaded holes as follows:
1. Remove any loose cured adhesive from the external threads of the components using a lint free cloth.
2. Thread the cleaned components into the internal mating threads and remove to loosen trapped cured adhesive.
3. Apply thread locking adhesive to the external threads of the components. Adhesives, Fluids, Lubricants, and Sealers
4. Ensure there are no gaps in the thread locking adhesive once applied to the component.
Courtesy of GENERAL MOTORS COMPANY

Rear Brake Caliper Bracket (1) - Install
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Fastener Caution

Rear Brake Caliper Bracket Bolt (1) - Install and tighten [2x]
- First Pass: 100 N.m (74 lb ft)
- Final Pass: 15 - 30 degrees
Courtesy of GENERAL MOTORS COMPANY

Disc Brake Pad Spring (1) - Install [2x]
Courtesy of GENERAL MOTORS COMPANY

Outer Disc Brake Pad (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Inner Disc Brake Pad (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Brake Caliper (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Brake Caliper Guide Pin Bolt (1) - Install and tighten [2x] - Rear Brake Caliper Replacement (JL9, J56) , or Rear Brake Caliper Replacement (J6H) , or Rear Brake Caliper Replacement (J57)
Connect the battery negative cable. Battery Negative Cable Disconnection and Connection
Install the tire and wheel assembly. Tire and Wheel Removal and Installation (without J57) , or Tire and Wheel Removal and Installation (with J57)
Calibrate the park brake. Park Brake Calibration