Installation Procedure
WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.
Remove the cap from the right rear brake rear pipe inlet.
- Maneuver the right rear brake front pipe (2) into the vehicle
- Rear Brake Front Pipe - Right Side (2) @ Rear Brake Pipe Clip (1) - Install [3x]
- Rear Brake Pipe Nut (3) - Install and tighten to 18 N.m (13 lb ft)
Exhaust Front Underbody Heat Shield- Right Side (3) - Install - Exhaust Front Underbody Heat Shield Replacement - Right Side
Warm Up Three-Way Catalytic Converter - Right Side (1) - Install - Warm Up Three-Way Catalytic Converter Replacement - Right Side (LT4)
Remove the cap from the rear brake front pipe outlet.
- Rear Brake Front Pipe - Right Side (2) @ Rear Brake Pipe Clip (1) - Install
- Rear Brake Pipe Clip (1) - Engage
- Rear Brake Pipe Nut (3) - Install and tighten - Rear Brake Front Pipe Replacement - Right Side (with Blackwing)
- Plenum Front Panel - Install - Plenum Front Panel Replacement (with Blackwing)
- Connect the battery negative cable. Battery Negative Cable Disconnection and Connection
- Bleed the brake system. Hydraulic Brake System Bleeding (J57, J6H, JL9) , or Hydraulic Brake System Bleeding (J56)
- Check the brake system for leaks.
- Remove the support and lower the vehicle.
CAUTION: