Removal Procedure
WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.
- Raise and support the vehicle. Lifting and Jacking the Vehicle
- Install the disc brake rotor protectors and remove the tire and wheel assembly. Tire and Wheel Removal and Installation (with J57) .
Wiring Harness Retainer (2) - Disengage
- Rear Disc Brake Pad Wear Sensor (1) @ Wiring Harness Retainer (2) - Remove
- Wiring Harness Retainer (3) - Disengage
- Rear Wheel Speed Sensor (4) @ Wiring Harness Retainer (4) - Remove
Rear Brake Hose Clip Bolt (1) - Remove [2x]
- Rear Brake Pipe Nut (2) - Remove
- Rear Brake Pipe Clip (3) - Remove
- Cap the rear brake pipe outlet to prevent brake fluid loss and contamination.
Rear Brake Hose Fitting (1) - Remove
- Rear Brake Hose Fitting Gasket (3) - Remove and DISCARD [2x]
- Rear Brake Hose (2) @ Rear Brake Caliper - Remove
- Plug the rear brake caliper inlet to prevent brake fluid loss and contamination.
Rear Brake Hose (1) - Remove
CAUTION:
Disc brake rotor protectors MUST be installed prior to tire and wheel assembly removal to avoid ceramic brake rotor damage due to contact between the tire and wheel assembly and the rotor. If the ceramic brake rotor is damaged replacement may be required.