Installation Procedure

WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Maneuver the right rear brake front pipe (2) into the vehicle.
Remove the cap from the rear brake pipe inlet.

CAUTION:

Refer to Fastener Caution .

Rear Brake Pipe Nut (1) - Install and tighten to 18 N.m (13 lb ft)
Rear Brake Front Pipe - Right Side (2) @ Front Brake Pipe Retainer (3) - Install
Courtesy of GENERAL MOTORS COMPANY

Front Brake Pipe (2) - Install
Remove the cap from the front brake pipe inlet.
Front Brake Pipe Nut (1) - Install and tighten - Front Brake Front Pipe Replacement - Right Side (with Blackwing)
Front Brake Pipe (2) @ Front Brake Pipe Retainer (3) - Install
Courtesy of GENERAL MOTORS COMPANY

Rear Brake Front Pipe - Right Side (2) @ Front Brake Pipe Retainer (1) - Install
Rear Brake Front Pipe - Right Side (2) @ Front Brake Pipe Retainer (3) - Install [2x]
Front Brake Pipe Retainer (1) - Engage
Courtesy of GENERAL MOTORS COMPANY

Brake Master Cylinder (1) - Install - Brake Master Cylinder Replacement - With Power Brake Booster and Electronic Brake Control Module (without MJK) , or Brake Master Cylinder Replacement - With Power Brake Booster and Electronic Brake Control Module (with MJK)