Installation Procedure
WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.
Maneuver the rear brake crossover pipe (1) into the left side of vehicle through the gap between the rear subframe and body.
Remove the plug from the rear brake hose inlet.
- Rear Brake Pipe Nut (1) - Install and tighten - Rear Brake Hose Replacement (J56, JL9) , or Rear Brake Hose Replacement (J6H) , or Rear Brake Hose Replacement (J57)
- Rear Brake Pipe Clip (3) - Install
- Rear Brake Pipe Clip (2) - Install
Remove the cap from the rear brake pipe union.
- Rear Brake Pipe Nut (2) - Install and tighten to 18 N.m (13 lb ft)
- Rear Brake Pipe Clip (1) - Install
Fuel Tank Filler Pipe (1) - Install - Fuel Tank Filler Pipe Replacement
- Rear Wheelhouse Liner - Left Side and Right Side - Install [2x] - Rear Wheelhouse Liner Replacement
- Connect the battery negative cable. Battery Negative Cable Disconnection and Connection
- Bleed the brake system. Hydraulic Brake System Bleeding (J57, J6H, JL9) , or Hydraulic Brake System Bleeding (J56)
- Fill the fuel tank.
- Inspect for fuel leaks.
CAUTION:
Refer to Fastener Caution .