Installation Procedure
WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.
Maneuver the front brake pipe (2) into the vehicle.
- Remove the plug from the front brake hose inlet.
- Front Brake Pipe Nut (1) - Install and tighten - Front Brake Hose Replacement (J56) , or Front Brake Hose Replacement (JL9) , or Front Brake Hose Replacement (J57, J6H)
- Engine Front Splash Shield- Left Side - Install - Engine Front Splash Shield Replacement (RWD)
- NOTE:
Some components not shown for graphic clarity.
Front Brake Pipe Retainer (1) - Install [2x]
- Remove the cap from the front brake pipe union.
- Front Brake Pipe Nut (2) - Install and tighten - Front Brake Front Pipe Replacement - Left Side (with Blackwing)
Air Conditioning Refrigerant Heat Exchanger (2) - Install - Air Conditioning Refrigerant Heat Exchanger Replacement (LT4)
- Connect the battery negative cable. Battery Negative Cable Disconnection and Connection
- Bleed the brake system. Hydraulic Brake System Bleeding (J57, J6H, JL9) , or Hydraulic Brake System Bleeding (J56)
- Install the left front tire and wheel assembly. Tire and Wheel Removal and Installation (without J57) , or Tire and Wheel Removal and Installation (with J57)
- Remove the support and lower the vehicle.
- Recharge the refrigerant. Refrigerant Recovery and Recharging
CAUTION:
Refer to Fastener Caution .