Installation Procedure
WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.
- Lubricate the brake master cylinder reservoir grommets with GM approved brake fluid from a clean, sealed brake fluid container. Adhesives, Fluids, Lubricants, and Sealers
Brake Master Cylinder Reservoir Grommet (1) - Install NEW [3x]
Secure the rear of the brake master cylinder reservoir (1) to the brake master cylinder and lower the front until it is fully installed.
- Brake Master Cylinder Reservoir Bolt (3) - Install NEW and tighten to 9 N.m (80 lb in)
Remove the cap or plug from the exposed hose and clutch master cylinder fittings.
- Install the clutch master cylinder reservoir hose (1) to the master cylinder reservoir.
- Fill the brake master cylinder reservoir to the maximum-full level with GM approved brake fluid from a clean, sealed brake fluid container. Brake Master Cylinder Reservoir Filling
Electrical Connector (1) @ Brake Fluid Level Sensor - Connect
- Front End Sheet Metal Cross Brace - Install - Front End Sheet Metal Cross Brace Replacement (Impact Bar Bracket) , or Front End Sheet Metal Cross Brace Replacement (Plenum with Blackwing)
- Connect the battery negative cable. Battery Negative Cable Disconnection and Connection
- Check for brake system leaks.
CAUTION:
Refer to Fastener Caution .