Installation Procedure
WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.
If removed, inspect the reverse lockout assembly O-ring (3). Replace the reverse lockout assembly O-ring if necessary.
- Install the reverse lockout assembly (4).
- Install the reverse lockout bolt (1) and tighten to 18 N.m (13 lb ft)
- Install the reverse lockout solenoid (2) and tighten to 40 N.m (30 lb ft).
Connect the reverse lockout solenoid electrical connector (1).
- Lower the vehicle.
CAUTION:
Refer to Fastener Caution .