Installation Procedure

WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

NOTE:
Some components not shown for graphic clarity.

Intermediate Steering Shaft Boot (1) - Install
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Some components not shown for graphic clarity.

Intermediate Steering Shaft Boot Nut (1) - Install and hand tighten [3x]

CAUTION:

Refer to Fastener Caution .

Intermediate Steering Shaft Boot Nut (1) - Tighten in sequence [3x] - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Mid Intermediate Steering Shaft (1) @ Upper Intermediate Steering Shaft (2) - Install
Prepare the mid intermediate steering shaft bolt (3) as follows:
1. Remove any loose cured adhesive from the external threads of the component using a lint free cloth.
2. Thread the cleaned component into the internal mating threads and remove to loosen trapped cured adhesive.
3. Apply thread locking adhesive to the external threads of the component. Adhesives, Fluids, Lubricants, and Sealers
4. Ensure there are no gaps in the thread locking adhesive once applied to the component.
Mid Intermediate Steering Shaft Bolt (3) - Install and tighten - Fastener Specifications
Remove the device used to prevent steering column rotation.