Component Testing
WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition/Vehicle - Off
- Disconnect the electrical connector: B27RR Rear Side Door Outside Handle Switch-Right
- Test for infinite resistance between the test points: Signal terminal 1 & Ground terminal 5 - Not Pressed
- If less than infinite resistance
Replace the component: B27RR Rear Side Door Outside Handle Switch-Right
- Go to next step: If infinite resistance
- If less than infinite resistance
- Test for less than 3 ohms between the test points: Signal terminal 1 & Ground terminal 5 - Pressed
- If 3 ohms or greater
Replace the component: B27RR Rear Side Door Outside Handle Switch-Right
- Go to next step: If less than 3 ohms
- If 3 ohms or greater
- All OK.