LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2021 >> CT4 Sport, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 220 (Engine Mechanical - 2.0L (LSY) - Repair Instructions (1 Of 3)) >> Repair Instructions >> Engine Mount Bracket Replacement - Left Side (RWD) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM5336818

    Engine Mount Bracket (2) - Install

    2. CAUTION:

    Refer to Torque-to-Yield Fastener Caution .

  2. Engine Mount Bracket Bolt (1) - Install NEW and tighten [3x] - Fastener Specifications
  3. GM5336825

    Engine Wiring Harness (2) - Install

  4. Retainer (1) - Install [3x]{ If equipped }
  5. GM5591894
    CAUTION:

    Phenolic spacer must be present to prevent galvanic/corrosive reaction and/or excessive temperature conduction between engine mount bracket and engine mount. Replace mount if phenolic spacer is missing or damaged. Failure to ensure phenolic spacer is intact and not damaged can lead to premature failure of engine mount and/or engine mount bracket.

    Ensure the phenolic spacer (3) remains in place.

  6. Engine Mount (2) - Install
  7. GM5420683

    Start the 2 NEW engine mount bolts (2) by hand.

  8. Using the adjustable jack, lower the engine on to the mount.
  9. Remove the jack from under engine.
  10. Connect the electrical connector.
  11. Lubricate the NEW oil filter gasket with clean engine oil.
  12. Oil Filter - Install NEW and tighten - Fastener Specifications
  13. Remove the drain pan.
  14. GM5420502

    Front Compartment Air Deflector (2) - Install

    15. CAUTION:

    Refer to Fastener Caution .

  15. Front Compartment Air Deflector Bolt (1) - Install and tighten [4x] - Fastener Specifications
  16. GM5396496

    Front Wheelhouse Liner Bolt (3) - Install and tighten - Fastener Specifications

  17. Engine Front Splash Shield Retainer (2) - Install [2x]
  18. Engine Front Splash Shield Bolt (1) - Install and tighten - Fastener Specifications
  19. GM5396453

    Front Wheelhouse Liner Bolt (1) - Install and tighten - Fastener Specifications

  20. Engine Front Splash Shield Retainer (2) - Install [2x]
  21. Engine Front Splash Shield Bolt (3) - Install and tighten - Fastener Specifications
  22. GM5396438

    Front Bumper Fascia Center Air Deflector Bolt (1) - Install and tighten [5x] - Fastener Specifications

  23. Front Bumper Fascia Air Deflector Retainer (2) - Install [2x]
  24. Lower the vehicle.
  25. GM5420683
    CAUTION:

    Refer to Torque-to-Yield Fastener Caution .

    Engine Mount Bolt (2) Tighten [2x] - Fastener Specifications

  26. Engine Mount Nut (1) - Tighten - Fastener Specifications
  27. Connect the battery. Battery Negative Cable Disconnection and Connection
  28. Fill the engine oil to the proper level with NEW engine oil.
  29. Start the engine and check for leaks.
scientia non olet · About LEMON Manuals