LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2021 >> CT4 Sport, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 158 (Engine Mechanical - 2.7L (L3B) - Repair Instructions (1 Of 3)) >> Repair Instructions >> Engine Mount Replacement - Right Side (RWD) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM5517335

    Engine Mount (1) - Install

  2. GM5517334
    NOTE:

    Do NOT tighten all of the way.

    Engine Mount Bolt (2) - Install NEW and hand tighten [2x]

  3. Lower screw jack until the engine sits on the mount.
  4. GM5517333

    Electrical Connector (1) @ Engine Mount (2) - Connect

  5. Remove screw jack and the block of wood under the transmission bell housing
    6. NOTE:

    Refer to the procedure link for torque specification.

  6. Oil Filter - Install - Engine Oil and Oil Filter Replacement (RWD)
  7. GM5414859

    Transmission Fluid Cooler Thermal Bypass Valve Gasket (1) - Install NEW [2x]

  8. GM5414854

    Transmission Fluid Cooler Pipe Seal (1) - Install NEW [2x]

  9. Transmission Fluid Cooler Seal (2) - Install NEW
  10. GM5414849

    Transmission Fluid Cooler Inlet and Outlet Pipe (2) - Install

    11. CAUTION:

    Refer to Fastener Caution .

  11. Transmission Fluid Cooler Pipe Nut (1) - Install and tighten - Fastener Specifications
  12. GM5414842

    Transmission Fluid Cooler Pipe Clip Bolt (3) - Install and tighten - Fastener Specifications

  13. Transmission Fluid Cooler Pipe Bolt (2) - Install and tighten - Fastener Specifications
  14. Transmission Fluid Cooler Pipe Connector Bolt (1) - Install and tighten [2x] - Fastener Specifications
  15. GM5517334
    CAUTION:

    Refer to Torque-to-Yield Fastener Caution .

    Engine Mount Bolt (2) - Tighten [2x] - Fastener Specifications

  16. Engine Mount Nut (1) - Install and tighten - Fastener Specifications
  17. GM5395459

    Turbocharger Heat Shield (1) - Install

  18. GM5395458

    Turbocharger Heat Shield Bolt (1) - Install and tighten [2x] - Fastener Specifications

  19. GM5395457

    Turbocharger Heat Shield Bolt (1) - Install and tighten [2x] - Fastener Specifications

  20. GM5399121
    NOTE:

    A special anti-seize compound is used on the heated oxygen sensor threads. The compound consists of liquid graphite and glass beads. The graphite will burn away, but the glass beads will remain, making the sensor easier to remove. New or service sensors will have the compound already applied to the threads. IF a sensor is removed and is to be reinstalled, the threads MUST have an anti-seize compound applied before installation. Adhesives, Fluids, Lubricants, and Sealers

    Using the EN-6179  Heated Oxygen Sensor Remover/Installer, install the heated oxygen sensor (1). Fastener Specifications

  21. Connect the electrical connector.
  22. Check the transmission fluid level. Transmission Fluid Level and Condition Check
  23. Fill the engine with the appropriate oil type and quantity.
  24. Start the engine and check for leaks.
scientia non olet · About LEMON Manuals