LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2021 >> CT4 Sport, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 157 (Engine Mechanical - 2.0L (LSY) - Repair Instructions (2 Of 3)) >> Repair Instructions >> Drive Belt Tensioner Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM5137021

    Drive Belt Tensioner (2) - Install

    2. CAUTION:

    Refer to Fastener Caution .

  2. Drive Belt Tensioner Bolt (1) - Install and tighten - Fastener Specifications
  3. GM4998850

    Crankshaft Balancer (2) - Install

  4. Crankshaft Balancer Bolt (1) - Install NEW and tighten - Fastener Specifications
  5. Raise and support the vehicle. Lifting and Jacking the Vehicle
  6. GM5084145

    Remove the EN-52476  Flywheel Lock and Alignment Tool (1) from the automatic transmission flexplate.

  7. GM5319715

    Starter (3) - Install

  8. Starter Bolt (2) - Install and tighten [2x] - Fastener Specifications
  9. Starter Stud (1) - Install and tighten - Fastener Specifications
  10. GM5460947

    Auxiliary Generator Battery Jumper Cable (2) - Install

  11. Battery Positive Cable Nut (1) @ Starter Solenoid - Install and tighten - Fastener Specifications
  12. GM5460935

    Electrical Connector (1) - Connect

  13. GM5460874

    Auxiliary Generator Battery Jumper Cable (3) - Install

  14. Battery Negative Cable Nut (1) @ Starter Stud - Install and tighten - Fastener Specifications
  15. Engine Wiring Harness Retainer (2) - Engage [2x]
  16. Lower the vehicle.
  17. GM5129786

    Accessory Drive Primary Belt (1) - Install

  18. GM5129599

    Use a suitable tool to rotate the drive belt tensioner (1) counterclockwise and hold.

  19. Slowly release tension on the drive belt tensioner.
  20. GM5068106

    Oil Level Indicator Tube Seal (2) - Install NEW

  21. Oil Level Indicator Tube (1) - Install
  22. GM5136547

    Oil Level Indicator Tube Bracket Bolt (2) - Install and tighten - Fastener Specifications

  23. Electrical Connector (1) @ Oil Level Indicator Tube (3) - Clip
  24. GM5335764
  25. Oil Level Indicator (1) - Install
  26. GM5335089

    Intake Manifold Cover (1) @ Upper Intake Manifold Bracket (2) - Install

  27. GM5335087
    NOTE:

    Ensure the engine sight shield retainers fully engage the intake manifold cover studs.

    Push down on the front of the intake manifold cover (1) engaging the intake manifold cover retainers to the intake manifold cover studs.

  28. Install the oil fill cap.
  29. Connect the battery. Battery Negative Cable Disconnection and Connection
scientia non olet · About LEMON Manuals