Installation Procedure
WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
Rear Center Seat Belt Retractor (3) - Install
- Rear Center Seat Belt Retractor Bolt -Rear (2) - Install and tighten - Fastener Specifications
- Rear Center Seat Belt Retractor Bolt -Front (1) - Install and tighten - Fastener Specifications
Rear Window Panel Trim (2) Install
- With the aid of an assistant, guide the rear window panel trim (2) rearward in the vehicle and downward to clear the speaker system.
- Route the center seat belt webbing through the trim (2).
- Ensure the rear window trim panel feet are seated into the rear window sheet metal drain shoe.
- Rear Window Panel Trim Retainer (1) - Install [3x]
{ If equipped } Connect the electrical connector.
- Quarter Upper Trim Panel (3) - Install [2x]
- Quarter Window Trim Finish Panel Bolt (2) Install and tighten [2x] - Fastener Specifications
- Quarter Window Trim Finish Panel Bolt Cap - Install [2x]
- Rear Seat Back Bolster (2) - Install [2x]
- Rear Seat Back Bolster Nut (1) - Install and tighten [2x] - Fastener Specifications
- Slide the rear seat back bolster retainer lock (1) toward the front of the vehicle.
- Rear Seat Cushion (1) - Install - Rear Seat Cushion Removal and Installation
- Enable the SIR System. SIR Disabling and Enabling .
CAUTION:
Refer to Fastener Caution .
CAUTION:
Refer to Fastener Caution .