LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2021 >> CT4 Sport, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 135 (12 V Starting And Charging - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P17DD-P17DF >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition Off, disconnect the connector (s) at the K212 Gear Shift Control Module.
  2. Verify a test lamp illuminates between ground circuit terminal 20 and B+
    • If the test lamp does not illuminate 

      Repair the open/high resistance on circuit 1450 or the ground connection.

    • Go to next step: If the test lamp illuminates 
  3. Ignition ON.
  4. Verify a test lamp illuminates between B+ circuit terminal 9 and ground.
    • If the test lamp does not illuminate and the circuit fuse is good 
    1. Test the B+ circuit 5140 for an open/high resistance.
      • If an open/high resistance is found, repair the fault on the circuit.
      • Go to next step: If an open or high resistance is not found
    2. Verify the fuse is not open and there is voltage at the fuse.
    • If the test lamp does not illuminate and the circuit fuse is open 
    1. Test the B+ circuit 5140 for a short to ground
      • If a short to ground is found, repair the fault on the circuit.
      • Go to next step: If a short to ground is not found
    2. Replace the control module.
    • Go to next step: If the test lamp illuminates 
  5. Verify voltage at B+ circuit terminal 9 is within 1 V of the C1 Battery voltage.
    • If not the specified value 

      Repair the high resistance on B+ circuit 5440.

    • Go to next step: If the specified value 
  6. Verify a test lamp illuminates between ignition circuit terminal 17 and ground.
    • If the test lamp does not illuminate and the circuit fuse is good 
    1. Test the ignition circuit 639 for an open/high resistance.
      • If an open/high resistance is found, repair the fault on the circuit.
      • Go to next step: If an open or high resistance is not found
    2. Verify the fuse is not open and there is voltage at the fuse.
    • If the test lamp does not illuminate and the circuit fuse is open 
    1. Test the ignition circuit 639 for a short to ground
      • If a short to ground is found, repair the fault on the circuit.
      • Go to next step: If a short to ground is not found
    2. Replace the K212 Gear Shift Control Module.
      • Go to next step: If the test lamp illuminates 
    3. Verify voltage at ignition circuit terminal 16 is within 1 V of the C1 Battery voltage.
      • If not the specified value 

        Repair the high resistance on ignition circuit 4320.

      • Go to next step: If the specified value 
    4. Replace the k20 Engine Control Module.
    • Go to next step: If the test lamp illuminates 
  7. Verify voltage at ignition circuit terminal 17 is within 1 V of the C1 Battery voltage.
    • If not the specified value 

      Repair the high resistance on ignition circuit 639.

    • Go to next step: If the specified value 
  8. Verify voltage at ignition circuit terminal 16 is within 1 V of the C1 Battery voltage.
    • If not the specified value 

      Repair the high resistance on ignition circuit 4320.

    • Go to next step: If the specified value 
  9. Replace the K212 Gear Shift Control Module.
scientia non olet · About LEMON Manuals