LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2021 >> CT4 Sport, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 135 (12 V Starting And Charging - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P1002 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition Off, disconnect the connector at the K111 Fuel Pump Power Control Module.
  2. Verify a test lamp illuminates between ground circuit terminal 14 and B+
    • If the test lamp does not illuminate 

      Repair the open/high resistance on circuit 2550 or the ground connection.

    • Go to next step: If the test lamp illuminates 
  3. Ignition ON.
  4. Verify a test lamp Illuminates between B+ circuit terminal 46 and ground.
    • If the test lamp does not illuminate and the circuit fuse is good 
    1. Test circuit 2640 for an open/high resistance.
      • if an open/high resistance is found, repair the fault on the circuit.
      • Go to next step: If an open or high resistance is not found
    2. Verify the fuse is not open and there is voltage at the fuse.
    • If the test lamp does not illuminate and the circuit fuse is open 
    1. Test circuit 2640 for a short to ground
      • If a short to ground is found, repair the fault on the circuit.
      • Go to next step: If a short to ground is not found
    2. Replace the K111 Fuel Pump Power Control Module.
    • Go to next step: If the test lamp illuminates 
  5. Verify voltage at B+ terminal 46 is within 1 V of the C1 Battery voltage.
    • If not within the specified value 

      Repair the high resistance on circuit 2640.

    • Go to next step: If within the specified value 
  6. Replace the K111 Fuel Pump Power Control Module.
scientia non olet · About LEMON Manuals