LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2021 >> CT4 Sport, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 135 (12 V Starting And Charging - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC B2B11 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition Off, disconnect the X1 connector at the K56 Serial Data Gateway Module.
  2. Verify a test lamp illuminates between ground circuit terminal 4 X1 and B+
    • If the test lamp does not illuminate 

      Repair the open/high resistance on circuit 2350 or the ground connection.

    • Go to next step: If the test lamp illuminates 
  3. Ignition ON.
  4. Verify a test lamp Illuminates between B+ circuit terminal 1 X1 and ground.
    • If the test lamp does not illuminate and the circuit fuse is good 
    1. Test the B+ circuit 5940 for an open/high resistance.
      • if an open/high resistance is found, repair the fault on the circuit.
      • Go to next step: If an open or high resistance is not found
    2. Verify the fuse is not open and there is voltage at the fuse.
    • If the test lamp does not illuminate and the circuit fuse is open 
    1. Test the B+ circuit 5940 for a short to ground
      • If a short to ground is found, repair the fault on the circuit.
      • Go to next step: If a short to ground is not found
    2. Replace the K56 Serial Data Gateway Module.
    • Go to next step: If the test lamp illuminates 
  5. Verify voltage at B+ terminal 1 X1 is within 1 V of the C1 Battery voltage.
    • If not the specified value 

      Repair the high resistance on circuit 5940.

    • Go to next step: If the specified value 
  6. Replace the K56 Serial Data Gateway Module.
scientia non olet · About LEMON Manuals