LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2021 >> CT4 Sport, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 133 (Engine Heating And Cooling - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P00B3-P00B5 (L3B) >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition/Vehicle - Off
  2. Disconnect the electrical connector: B203 Radiator Coolant Temperature Sensor
  3. Test the resistance between the test points: Signal terminal 1 & Low Reference terminal 2
  4. Verify the value is within the range listed in the table:Temperature Versus Resistance - Engine Coolant Temperature Sensor
    • If not in the specified range 

      Replace the component: B203 Radiator Coolant Temperature Sensor

    • Go to next step: If in the specified range 
  5. Test for infinite resistance between the test points: Each terminal of the component & The component's housing
    • If less than infinite resistance 

      Replace the component: B203 Radiator Coolant Temperature Sensor

    • Go to next step: If infinite resistance 
  6. All OK.
scientia non olet · About LEMON Manuals