Transmission Case

WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Transmission Fluid Cooler Inlet Pipe Fitting (1) - Remove and DISCARD
Transmission Oil Filler Plug (2) - Remove
Manual Transmission Fluid Temperature Sensor (3) - Remove
Courtesy of GENERAL MOTORS COMPANY

Transmission Fluid Auxiliary Cooler Pipe Bracket Bolt (1) - Remove
Transmission Fluid Auxiliary Cooler Pipe Bracket (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Transmission Case Locating Pin (1) - Remove [2x]
Transmission Magnet (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Do not replace the bearing cup unless inspection shows bearing cup damage.

Using DT-8092 Drive Handle (1) and J-39790-A Mainshaft Bearing Race Remover (2), remove the counter gear bearing cup (3).
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Do not replace the bearing race unless inspection shows bearing race damage.

Using DT-8092 Drive Handle (1) and J-39790-A Mainshaft Bearing Race Remover (2), remove the mainshaft bearing race (3).
Courtesy of GENERAL MOTORS COMPANY

Using J-36190 Universal Driver Handle (1) and J-44384 Shift Fork Bearing Installer (2), remove the shift shaft bearing (3).