Circuit/System Description

WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.

The driver and passenger heated seats switches are located with the S48A Multifunction Switch - Instrument Panel. To operate the heated seats the engine must be running. When a heated seat switch is pressed, a serial data message is sent from the S48A Multifunction Switch - Instrument Panel to the K9 Body Control Module (BCM) indicating the heated seat command. The BCM serves as the heated seat system master to determine the requested operating mode. The BCM then sends a LIN bus serial data message to the K29F Front Seat Heater Control Module indicating the heated seat command. In response to this message, the K29F Front Seat Heater Control Module attempts to drive the appropriate seat heating elements per the BCM command. The BCM also controls the seat temperature and mode indicators, via the serial data line, used to provide the operator with feedback as to the operating status of the system.

The K29F Front Seat Heater Control Module controls heated seat operation for the driver and passenger seats. When active, power is applied to the seat cushion and back heater elements through a common pulse width modulated (PWM) voltage supply control circuit. Each individual heater element is switched to ground by the module through a common low side drive control circuit.

The seat back and cushion temperature sensors (thermistors) are packaged with the seat heating elements located just under the seat covers. The K29F Front Seat Heater Control Module supplies each temperature sensor with a 5 V reference signal circuit and a low reference circuit. The module monitors the voltage from the signal circuit to determine the temperature of the seat.

The temperature sensor varies in resistance based on the temperature of the heating element causing the signal voltage to change. Once the module senses the seat reached the set temperature, it will then begin regulate the current flow through the heater elements in order to maintain the desired seat temperature based on the feedback voltage from the sensor.